User's Manual

Take Button
When the Enable Take Button checkbox is active, the lower right button on the control interface
turns red. Use this if you want a confirmation option to come up before your route change takes
place. Press the red take button to confirm your route change. The take button can be used
with both Cut-Bus and XY controller configurations and can also be used with macros.
The Take button illuminates red in the lower right corner.
Backlight
Adjust the backlight slider to vary the brightness of the backlit buttons as desired. Enable
Backlight Destinations Only if you wish to disable the backlighting of the white source buttons.
Configuring GPIs
The GPI and Tally Interface has 8 GPIs that provide crosspoint switching. In the example on the
left, if GPI 1 detects a contact closure it will switch Input 12 on your Videohub to Output 1. This
means when you switch the joystick control on your CCU, video going to Input 12 of your
Videohub will be previewed on your monitor.
The crosspoints can be configured in the Videohub Hardware Panel Setup simply by clicking
inside the Input and Output fields on the diagram and typing in the Input or Output number.
The Videohub Control Settings pane offers two ways to preview the output from
your Videohub.
Click inside the diagram to change inputs and outputs for GPI crosspoint switching and Tally.
69Blackmagic Videohub Software