User's Manual

Blackmagic Videohub Hardware Panel Setup network settings.
If you are setting up hardware panel control for an IP Videohub, enter the host computer’s
IPaddress in the ‘remote Videohub IP’ setting field. The Videohub server shares the same
IPaddress with the host computer.
Add Videohub Control
If you already know the IP address of a Videohub control panel but it hasn’t automatically
appeared in the Videohub Control Panels pane, you can add the unit manually.
1 Press the + (add device) button at the bottom of the Videohub Control Panels pane.
2 Type in the IP address of the Videohub Control Panel and press OK.
3 The Videohub Control Panel will appear in the list with any other devices that are
connected to the Videohub.
If the Blackmagic Videohub Hardware Panel Setup does not find a Videohub control panel at
the specified address, you can use the Utility to manually add a Videohub control panel when
connected via Ethernet or USB.
You can manually add a Videohub control panel, by
IP address, to the list of Videohub Control Panels.
Load/Save Settings
You can apply settings from an already configured Videohub control panel to other units.
Once you have set up your Videohub Control Panel’s settings, choose File>Save Settings.
This is useful if you want to set up several units the same way, or keep a back up of
your settings.
After loading pre-configured settings on another control panel, you only need to update
network settings, including the control panel name.
65Blackmagic Videohub Software