User's Manual

Download the Videohub software to your iPad
Videohub settings on iPad
Videohub Hardware Panel Setup
When you launch Blackmagic Videohub Hardware Panel Setup, any Videohub control panels
discovered on the network will be listed in the Videohub Control Panels pane next to an
Ethernet network icon. If several Videohub control panels are listed, but you don’t know which
one is which, select one of them and then press Identify. This will cause all the buttons of the
selected Videohub control panel to flash white.
Select the desired Videohub control panel and you will be able to change its name and control
settings. Network settings will remain grayed out and can only be changed via USB.
If the desired Videohub control panel is not found on the network, the unit might not have
received an IP address via DHCP. To manually configure the unit with appropriate network
settings:
1 Connect the Videohub control panel to your computer via a USB 2.0 cable.
2 Launch Blackmagic Videohub Hardware Panel Setup. If the utility prompts you to
update the software, follow the prompts to complete the update.
3 The USB-connected panel will be automatically selected in the Videohub Control
Panels pane and will display a USB icon next to its name. You can change all name,
network and control settings for the USB-connected unit. When you are finished, the
USB cable can be removed.
If your Videohub control panel is selected in the control utility, the pushbuttons on the unit will
light up to match what is displayed in the software interface.
63Blackmagic Videohub Software