User's Manual

Locking and Unlocking Routes
To lock a destination using Videohub Master Control:
1 Set the destination and source using whichever method you prefer. Once the route has
been set, Videohub Master Control will return to its idle state.
2 Press the DEST button. The destination field will highlight blue on the LCD.
3 If the desired route is not already displayed on the LCD, use the pushbuttons and/or
scroll wheel to find the destination to be locked.
4 Press and hold the gold DEST button until a lock icon appears in the destination field
of the LCD.
5 Press DEST again to return Videohub Master Control to its idle state and the destination
field will revert to gray.
The destination field shows a lock icon if the destination is locked.
To unlock a destination using Videohub Master Control:
1 Press the DEST button. The destination field will highlight blue on the LCD.
2 If the desired route is not already displayed on the LCD, use the pushbuttons and/or
scroll wheel to find the destination to be unlocked. The destination field will show a
lock icon for the locked destination.
3 Press and hold the gold DEST button until the lock icon disappears from the destination
field of the LCD.
4 Press DEST again to return Videohub Master Control to its idle state and the destination
field will revert to gray.
The lock icon disappears from the destination
field when the destination is unlocked.
Using Macros
If you press a green macro button, it will simultaneously make the crosspoint changes you have
previously configured in Videohub Hardware Panel Setup. Each button can be configured with
up to 16 crosspoint routes. If you have the Take button enabled, the simultaneous change of
routes will only take place when you confirm by pressing the Take button. If for any reason the
macro cannot be performed, the button will flash.
23Videohub Hardware Control Panels