User's Manual
Mounting and connecting URSA Mini SSD Recorder
URSA Mini SSD Recorder mounts to the back of URSA Broadcast directly behind the camera
body, using your camera’s rear SDI in and SDI out BNCs to pass data to and from URSA Mini
SSDrecorder. It’s worth noting that because the recorder uses these SDI inputs and outputs,
you can’t simultaneously connect your camera to an ATEMswitcher.
To mount and connect URSA Mini SSD Recorder:
1 2
SDI OUT
SDI IN
REF IN
TC IN
12V
Power off URSA Broadcast by moving the
‘power’ switch to ‘off’.
Unmount any battery plates currently fittedto
your camera. For more information on mounting
and unmounting battery plates, see the section
'mountingbatteries' in this manual.
TIP URSA Mini SSD Recorder features a passthrough cable for your camera’s battery
power supply, so you can attach V-mount or gold mount batteries to the rear of the
camera behind the recorder.
SDI OUT
SDI IN
REF IN
TC IN
12V
NOTE Before installing URSA Mini SSD Recorder, you’ll need to update your camera's
internal software to version 4.8 or higher using Blackmagic Camera Setup Utility. For
more information on updating your camera firmware see the section 'Blackmagic
Camera Setup Utility' in this manual.
180180URSA Mini SSD Recorder