User's Manual

SDI OUT
SDI IN
REF IN
TC IN
12V
3
SDI OUT
SDI IN
REF IN
TC IN
12V
4
If no battery was fitted to your camera,
youmayneed to remove the cover over the
molex socket on your camera's rear panel. Use a
philipshead screwdriver to remove the
fourM3screws holding the cover in place.
Attach URSA Mini SSD Recorder’s
mountingbracket using 6 x T10 torx screws.
SDI OUT
SDI IN
REF IN
TC IN
12V
5
SDI OUT
SDI IN
REF IN
TC IN
12V
6
Plug the molex connector on URSA Mini
SSDRecorder into the molex socket on
yourcamera’s rear panel.
Attach URSA Mini SSD Recorder to the mounting
bracket using 2 x T10 torx screws onthe left and
right side of the brackets.
7
SDI OUT
SDI IN
REF IN
TC IN
12V
8
Connect the SSD Recorder’s SDI In and SDIout
cables to the SDI inputs and outputs on the back
of your camera. The SSD Recorder’s cables are
marked ‘in’ and ‘out’ tohelp matchthem to the
appropriate connector on your camera.
If you want to use a battery plate with URSAMini
SSD Recorder, use a 2mm hex key driver to
remove the four M3 screws holding the molex
socket cover panel in place. Once the molex
socket is uncovered, attach a battery plate using
the steps outlined in the section ‘mounting
batteries’ inthis manual.
181181URSA Mini SSD Recorder