User's Manual

10 点 按“
Finish
”完成安装，然后点按“
Yes
”重 启
Smart Remote
4
。
Smart Remote
4
会重新启动并自动启用最新版本的
Ultimatte Smart Remote
4
控制面板。
连接
USB
键盘和鼠标
如果您希望通过键盘和鼠标控制
Ultimatte Smart Remote
4
，只需将其连接到后面板上的
USB
端口。
Smart Remote
4
会 自 动 将 键 盘 和 鼠 标 检 测 为 即 插 即 用 设 备 ，您 可 以 像 使 用
Windows PC
一样控制您
的
Smart Remote
4
。
Developer Information
Controlling Ultimatte using Telnet
The Blackmagic Ultimatte 12 Ethernet Protocol gives you the freedom to build your own custom
control solutions for your Ultimatte 12. For example, you can create your own software
application and control your Ultimatte 12 via Ethernet from your computer.
The first step is to connect your Ultimatte to your computer via Ethernet. You can do this by
connecting Ultimatte to the same network your computer is connected to, or you can connect
Ultimatte directly to your computer.
NOTE If Ultimatte 12 is connected directly to your computer, set your computer to a
manual static IP address. Set the first three blocks of numbers in the IP address
tomatch your Ultimatte 12 and set the subnet mask to 255.255.255.0. You can leave
thegateway or router setting blank as it will not be used in a direct connection between
your computer and Ultimatte 12.
If your network settings are set correctly, you can now open the Terminal application on
MacOS, or enable Telnet command line utilities on Windows and enter Ultimatte control
protocol commands. These commands can be programmed into your application and triggered
by related items on a custom user interface of your own design.
Developer Information
398