User's Manual

DVE Key Settings
Performing an Upstream DVE Key
To set up a DVE key on upstream keyer 1 on the software control panel:
1 Expand the upstream key 1 M/E 1 palette and select DVE from the key types bar.
2 Select the fill source. You can even select the ME 2 program or preview output as the
DVE fill source which gives you a tremendous amount of control and creative options.
3 Adjust the key parameters to refine the key. For a description of DVE key parameters,
refer to the table below.
DVE Key Settings
To set up a DVE key on upstream keyer 1 on an ATEM advanced panel:
1 Press the KEY 1 next transition button to enable the keyer on the preview output.
2 In the keyers LCD menu, select the DVE key type using the corresponding soft
control knob.
3 Select the fill source using the corresponding control knob or via the a source button
on the source select bus.
4 Press the system control left and right arrow buttons to navigate through the DVE
parameters and use the soft control knobs to adjust settings, such as rotation, position,
size, mask settings, light source, border and key frames for movement.
147Keying using ATEM Switchers