User's Manual

Clip The clip level adjusts the threshold at which the key cuts its hole into the
clip that is playing back through the media player. Decreasing the clip level
reveals more of the background. If the background video is completely black
then the clip value is toolow.
Gain The gain adjustment electronically modifies the value which allows the
softening of the edges of the key in the clip that is playing back on the media
player. Adjust the gain value until the edge softness is desirable but the
background video luminance (brightness) is not affected.
Invert Key Inverts the key.
Stinger Transition Settings
To perform a stinger transition on an ATEM advanced panel:
1 Press the ‘sting’ transition type button in transition control block.
2 Rotate the LCD menu soft control knob labelled ‘source’ to select the desired media
player. Use the arrow buttons to adjust the preroll, trigger, mix and duration times
as needed.
3 Now that you have set the stinger transition to use the correct media player, press the
‘media players’ button in the system control menu buttons next to the LCD to configure
the media player.
4 In the media players menu, select the still or clip you want to use from the media pool
by rotating the ‘media’ soft control knob. If required, set which frame you want to start
the clip from using the corresponding ‘frame’ soft control knob.
NOTE You can also use a HyperDeck as a source for the stinger if you have a
HyperDeck connected to your switcher and configured correctly. Refer to the
‘HyperDeck control’ section of the manual for more information.
5 Perform the transition as an auto transition from the transition control block.
126Operating your ATEM Switcher