User's Manual

Connecting the Panel to your Switcher
To connect ATEM Camera Control Panel to your switcher, all you need to do is add the panel
into your ATEM Ethernet connection chain.
For example, if you are using an external ATEM hardware panel, such as the ATEM 1 M/E
Advanced Panel, remove its Ethernet cable from your computer or network and connect it to
one of the camera control panel’s Ethernet ports instead. The ATEM hardware panel will then
be the middle unit in the chain. Now connect the camera control panel’s spare Ethernet port to
your computer or network.
Computer
Ethernet
Ethernet
ATEM Camera Control Panel
ATEM 1 M/E Advanced Panel
Ethernet
ATEM 1 M/E Production Studio 4K
If you are using the camera control panel with just your switcher and a computer on a shared
network, connect the panel to your switcher, then the spare Ethernet port to your computer.
ATEM 4 M/E Broadcast Studio 4K
Ethernet
Computer ATEM Camera Control Panel
Ethernet
After connecting the camera control panel to your ATEM equipment, you should see the lights
on the panel illuminate and the LCDs on each CCU will display their respectively assigned
cameras. The panel is now powered, connected to your switcher and ready to start controlling
your cameras!
197Using ATEM Camera Control Panel