User's Manual

This will now allow the art to be placed over the enabled box or boxes. If your art is not Pre
Multiplied then you can use the clip and gain controls as discussed in the Keying section of this
manual to achieve the desired result. You may also need to invert the key.
Art Foreground controls
Adjusting Borders
Borders are created the same way for both the GUI and the ATEM panel. Simply click on the
button marked Borders. This will allow access to all the border parameters as previously
discussed in this manual under “Adding DVE borders”.
Please note that if you are using the Art in Foreground mode then the borders are not available
as they would not be visible and that any or all border settings are applied to all boxes. Also
note that ATEM Constellation 8K presents SuperSource without borders in 8K.
Copying Settings
To perform the Copy function using the GUI, simply click on the Copy button and the Copy Box
Settings dialogue will appear. You can quickly & easily copy the settings of the currently
selected box to any of the other boxes, making an exact clone in just one click! The copied
boxes will appear directly behind the master box and will also share the same source as
the master.
180Operating your ATEM Switcher