User's Manual
Gain
The gain adjustment electronically modifies the value which allows the softening of the
edges of the key in the clip that is playing back on the media player. Adjust the gain
value until the edge softness is desirable but the background video luminance
(brightness) is not affected.
Invert Key
Inverts the key.
Stinger Transition Settings
To perform a stinger transition on the broadcast panel
1 From the system control menu buttons, navigate to the media player menu by selecting
MEDIA PLAYER from the home menu and select the media player you plan to use for
the transition.
2 Select the CLIPS button and then use the first knob to select between clips 1 or 2.
3 Select stinger as the transition type by pressing the STNG button on the ATEM 2 M/E
Broadcast Panel. On the ATEM 1 M/E Broadcast Panel, pressing the DIP/MIX and
DVE/WIPE buttons simultaneously illuminates Both buttons green indicating that the
stinger transition type is selected.
4 From the system control menu buttons, select the media player you chose in step 1.
Youcan also navigate to the stinger menu by selecting TRANS > STINGER from the
HOME menu.
5 Adjust the preroll, trigger, mix and duration times as needed.
6 Set the logo rate and any other key parameters if required.
7 Perform the transition as an auto transition from the transition control block.
You cannot perform a manual stinger transition using the fader bar.
To perform a stinger transition on the ATEM 1 M/E Advanced Panel
1 Press the ‘stinger’ transition type button in transition control block.
2 Rotate the LCD menu soft control knob labelled ‘source’ to select the desired
media player.
3 Now that you have set the stinger transition to use the correct media player, press the
‘media players’ button in the system control menu buttons next to the LCD to configure
the media player.
148Operating your ATEM Switcher