User's Manual
ATEM 2 M/E Production Studio 4K supports SD, HD and Ultra HD video and is capable of
switching 20 external inputs from its SDI and HDMI connectors. Input 1 is selectable between
the HDMI Input 1 and SDI Input 1 connector. The front panel keypad allows on-the-fly selection
of the 6 auxiliary output sources and the large LCD gives instant confirmation of your aux
output content.
ATEM 2 M/E Production Studio 4K
ATEM 4 M/E Broadcast Studio 4K supports HD and Ultra HD video and is capable of switching
20 external SDI inputs. Features include 4 media players, advanced chroma keying, Ultra HD
multi views and 12G-SDI support for Ultra HD frame rates up to 2160p59.94 on a single BNC
connector. The front panel keypad lets you select between 6 auxiliary output sources and you
can monitor the outputs on the large built in LCD.
ATEM 4 M/E Broadcast Studio 4K
NOTE If you have an ATEM 2 M/E Broadcast Studio 4K, you can update your
switcherto ATEM 7.3 or later and enable all the same features that are available on
ATEM 4 M/E Broadcast Studio 4K. This means you can update your ATEM 2 M/E
Broadcast Studio 4K switcher to an ATEM 4 M/E Broadcast Studio 4K simply by
updating the internalsoftware.
Plugging in Multi View Monitoring
The ATEM can be a little intimidating when first seen, especially since some models have no
controls to access, just lots of connectors! So the first step is to plug in power and a monitor and
see it working! ATEM switchers have a front control panel with a built in LCD so you only need
to connect power to see them working!
A convenient way to check that your ATEM is powered on and working correctly is to plug an
HDMI television or SDI monitor into the multi view output on the right side of the rear panel.
10Getting Started