User Manual

ATEM Software Control menus for routing outputs for ATEM Constellation 8K.
Routing Auxiliary Outputs
On the ATEM software control each aux output has a menu for selecting the source to output
on the aux video output. Select the menu and then scroll the list for the source you want to
output. When selected, the output on the selected aux will change immediately. You can see
the current source with a tick in the menu item.
On the ATEM broadcast panel the aux outputs are set from the aux menu in the system control.
Once the desired aux output is selected, you use the select bus to route the source to the aux
output. Because the broadcast panel uses the select bus, it’s very fast to control aux outputs
from the broadcast panel.
Auxiliary outputs are assignable on the ATEM 2 M/E Broadcast Panel using the Destination bus.
Once the desired Aux is selected in the Destination bus, you can use the Select bus to assign
an input to it.
Whatever video and audio is output on Aux 1 is also output on the USB 3.0 port.
There are a range of sources available and these include:
Black
Black source generated internally in the switcher.
Inputs
You will see the video inputs of the switcher listed and these will be listed as the
current labels you have set in the settings window of the switcher.
Color Bars
Color bar source generated internally in the switcher.
Media Player 1
This is the fill output of media player 1 and is derived from the still or clips RGB content.
176Operating your ATEM Switcher