User's Manual

If you want to manually trigger the playback, for example holding on a still frame then rolling,
simply disable the respective HyperDeck’s auto roll checkbox in the ’HyperDeck’ tab in
ATEMsoftware’s ‘settings’ menu.
Recording
To record to a HyperDeck with a formatted disk inserted, simply press the ‘record’ button in the
HyperDeck palette transport controls. The ‘time remaining’ indicator in the HyperDeck palette
will let you know the approximate recording time remaining in the SSD.
Controlling HyperDecks with External Hardware Panels
If you are using an external ATEM hardware panel, you can control any connected HyperDecks
using the hardware panel. Once you have connected your HyperDecks to your switcher as
described in the 'connecting HyperDecks' section, you can use the system control buttons and
LED menu on your panel to set up and control each HyperDeck.
HyperDeck Setup with ATEM Advanced Panels
Once you have connected your HyperDeck to your switcher, as detailed in the ‘connecting
HyperDecks’ section, use ATEM Advanced Panel’s system control and LCD soft buttons to
setup and control your HyperDecks.
To begin, press the system control ‘settings’ button.
You’ll notice that ATEM advanced panels display four setup options along to top of the LCD
screen. These include ‘switcher,’ ‘panel,’ 'HyperDecks,' and ‘button mapping.’ Each corresponds
to a setup menu. Simply press the LCD soft button above 'HyperDecks' to enter
the ‘HyperDeck settings’ menu.
The HyperDeck settings menu has three pages, which you can select using the ‘left’ and ‘right’
arrow buttons in the system control panel, or by pressing the ‘1,’ ‘2,’ and ‘3’ buttons on your
ATEM advanced panel's numerical keypad.
Assigning an input to a HyperDeck
In the first menu page, you’ll see the ‘HyperDeck’ indicator in the bottom left corner, and an
‘input’ indicator.
Use the control knob under the ‘HyperDeck’ indicator to cycle through the available HyperDecks.
Once you have selected a HyperDeck, simply rotate the knob under the ‘input’ indicator to
select which input that HyperDeck is connected to on your switcher. For example, if
HyperDeck1 is connected to SDI In 4 on your switcher, rotate the knob under the ‘input’
indicator to select ‘camera 4.’ Press the ‘input’ knob to confirm your selection.
77HyperDeck Control