User's Manual

The input labels settings let you customize the name of each input label, and these labels
appear on the multi view. If you are using an additional ATEM advanced panel, the long and
short labels allow for the long label to fit into the advanced panel's display.
A short 4 character name is used to identify the video input on the source names display of in
ATEM Software Control. The longer input names support up to 20 characters and are displayed
in various dropdown source selection boxes on the software control panel, on the multi view
windows on screen labels and also on ATEM advanced panels.
To change an input name, click in the text field, enter the text and click 'save'. The input name
will be updated on the multi view, software control panel and hardware panel if one is
connected. It’s a very good idea to change both the short and long labels at the same time, so
they match. For example Camera 1 would be entered in as a long label, and CAM1 as the
short label.
HyperDeck Settings
HyperDeck settings
Connect up to 4 Blackmagic HyperDeck Studio disk recorders and control them using
ATEM Software Control. When connecting HyperDecks, use these settings to configure the
IPAddress, select the inputs your HyperDecks are connected to, turn the auto roll feature for
each deck on or off, and set their frame offset settings so they can switch cleanly.
Status indicators appear above and below each deck so you can easily see if they are
successfully connected and if their remote buttons are active.
For detailed information on setting up Blackmagic HyperDecks with your ATEM switcher and
setting the ‘HyperDeck’ configuration settings, refer to the ‘HyperDeck control’ section of
this manual.
Remote Settings
Use the 'remote' settings to tell your switcher how to use the RS-422 remote port. The options
are none, VISCA and GVG, where GVG sets it to use GVG100, a common legacy interface for
communicating with equipment such as linear editing suites.
59Using ATEM Software Control