User's Manual

Because of the limited space on the front panel, both the program and preview rows have been
combined together into a single row of buttons. You can see the source selected on the
program row because it’s illuminated red. You can see the source selected on the preview row
because it’s selected green. These are the same colors as the software control panel, but they
are just on the same row of physical buttons.
Multiple computers can run ATEM Software Control simultaneously, which means
multiple operators can be dedicated to separate controls on your switcher, for
example media management, audio mixing and camera control
Changing Switcher Settings
Clicking on the switcher settings ‘gear’ icon will open the settings window where you can
change general switcher settings, Multi View, label, HyperDeck and remote settings.
Thesesettings are divided into tabs.
General Settings
Setting the Switcher Video Standard
The video setting is used to select the operating video standard of the ATEM switcher. For HD
model ATEM Television Studio switchers, this must be set to the same video standard as the
video sources you are plugging into the ATEMswitcher. If they don’t match, the inputs won’t
appear correctly, and will most likely remain black. A good way to work out the video standard
you should use is to check your cameras, and then set the switcher video standard to the
same format.
NOTE On ATEM Television Studio Pro 4K, all inputs will automatically convert any
HDor Ultra HD video format to match any HD or Ultra HD video standard set in the
switcher settings.
54Using ATEM Software Control