User's Manual

To change the network settings via Blackmagic ATEM Setup:
1 Connect the switcher via USB to the computer running the setup utility software.
2 Launch Blackmagic ATEM Setup and select your switcher or hardware panel.
3 The switcher’s current IP address, subnet mask and gateway settings will be displayed
in ‘configure’ window. If you only want to check the IP address and not change it,
youcan simply quit the setup utility by clicking ‘cancel’.
4 To change the IP address or any other settings, simply edit the numbers and then
click ‘save’.
5 A dialog box will prompt you to power cycle your ATEM switcher. Turn the switcher’s
power off, turn it back on and then close the dialog box.
Change network settings using the ‘configure’ tab in Blackmagic ATEM Setup.
Understanding External Hardware Panel Network Settings
If you are using an external ATEM hardware panel, the hardware panel's network
settings are configured from the network setup menu in the hardware panel's system
control, or using the system control LCD menu on ATEM Advanced Panels. Along with
its own IP address, the hardware panel also needs to be configured with the network
location of the switcher, so that communication between the two devices can be
established over the Ethernet connection. If the hardware panel’s network settings are
correctly configured, you will see the panel light up and buttons turn on so you can
control the switcher.
If the hardware panel is displaying a message looking for the switcher, then you will
need to set the hardware panel’s network settings so that the panel and switcher
share the same subnet, and the network location to which the hardware panel is trying
to connect, matches the switcher’s IP address. The following section shows you how to
set the switcher IP location on your ATEM hardware control panel.
27Connecting to a Network