User's Manual

Mix minus settings in the audio tab let you mute the corresponding input
from its program return output on some ATEM switcher models
The mix minus settings on SDI outputs let you mute the corresponding input from its program
return output. For more information, refer to the section titled, ‘Changing Switcher Settings/
Setting the Audio Output Behavior’.
The audio follow video settings let you set the switcher to use a default short crossfade when
switching sources with AFV enabled, or use a duration set by your transition rate setting. For
more information refer to the ‘Using ATEM Software Control/changing switcher settings’ section.
Label the Video Inputs
When setting up your project, you may want to change the input labels. These labels appear
on the multi view and any connected ATEM hardware panels. There are two labels to change,
including a long label used in software, and the short label that’s limited to 4 digits and used in
external ATEM hardware panels.
Set Video Input and Labels
17Getting Started