User's Manual

To perform a DVE transition on an ATEM Television Studio Pro model switcher:
1 On the preview bus, select the video source that you want on the program output.
2 To select a DVE, press any of the DVE push or DVE squeeze pattern buttons. If you
want to change the direction of the DVE, press the invert button.
NOTE If the DVE is already being used in an upstream key, the DVE transition
type will not be available for selection until the key is taken off air and off next
transition. Refer to ‘sharing DVE resources’ later in this section for
moreinformation.
3 Perform the transition as an auto transition or manual transition using the auto button or
transition slider.
To perform a DVE transition on the software control panel:
1 On the preview bus, select the video source that you want on the program output.
2 Select the DVE transition style in the transition control block.
3 Expand the transition palette and select DVE from the transition types bar.
If the DVE is being used in an upstream key, the DVE transition style button will be
unavailable for selection until the key is taken off air and off next transition. Refer to
sharing DVE resources below for more information.
4 Use the settings in the DVE palette to customize the transition.
5 Perform the transition as an auto transition or manual transition from the transition
control block.
DVE transition settings
115Operating your ATEM Switcher