User's Manual

To perform an auto transition on ATEM Television Studio HD:
1 Select the desired source by pressing one of the source buttons on the control panel.
2 Make any adjustments to the source audio if required by rotating the settings knob.
3 In the LCD menu, set the transition type, transition rate and adjust any other parameter
for the transition as needed.
4 When you are happy with the audio level for the selected source, press the 'auto'
button next to the LCD to perform the transition.
5 For more detailed information, refer to the section titled, 'using the ATEM Television
Studio HD front panel'.
To perform an auto transition on an ATEM Television Studio Pro model switcher:
1 In the preview row of buttons, select the video source that you want on the
program output.
2 Select the transition type using the transition type buttons on the control panel.
3 In the LCD menu, set the transition rate and adjust any other parameter for the
transition as needed.
4 Press the auto button on the control panel to initiate the transition.
5 During the transition, the red and green buttons on the program and preview buses
both turn red to indicate that you are in the middle of a transition. The transition slider
indicator displays the position and progress of the transition.
6 At the end of the transition, sources selected on the program and preview buses are
exchanged to indicate that the video source that was on preview is now on program
and vice versa.
Each transition type has its own independent transition rate allowing the operator to
perform faster transitions by simply selecting the transition type and pressing the AUTO
button. The previously used transition rate is remembered for that transition type until it
is changed.
To perform an auto transition on the software control panel:
1 On the preview bus, select the video source that you want on the program output.
2 Select the transition type using the TRANSITION STYLE buttons in the transition
control block.
3 In the transition palette, select the settings tab for the same transition type as the
transition control block.
4 Set the transition rate and adjust any other parameter for the transition as needed.
5 Press the AUTO button in the transition control block to initiate the transition.
6 During the transition, the red and green buttons on the program and preview buses
both turn red to indicate that you are in the middle of a transition. The virtual fader bar
automatically follows the progress of the transition and the rate display updates to
indicate the number of frames remaining as the transition progresses.
7 At the end of the transition, sources selected on the program and preview buses are
exchanged to indicate that the video source that was on preview is now on program
and vice versa.
108Operating your ATEM Switcher