User's Manual

To adjust an input audio level, for example on input 4:
1 Select the input 4 button. This is easier when using program/preview mode as you can
just select it on the preview source.
2 The LCD will change to that input and for this example input 4 would be displayed
on the LCD.
3 Now adjust the knob and you will see the small 4 LED audio meter will reduce in level.
If this input is on air, you will also see the master audio output will be reduced because
this input is being lowered in level.
The small 4 LED meters above each input let you quickly identify if a specific input audio level is too
high and you can adjust it by pressing the respective input button and then adjusting the control knob
To go back to the master audio level:
1 Press the set button on the right side of the control panel and it will go back to master.
After a few moments, the front panel will automatically switch itself back to master too.
2 Now adjusting the knob will be adjusting the master audio output and the LCD has
master displayed.
Fading the Downstream Key 1
You can trigger the downstream key 1 from the front panel by using the DSK 1 MIX button.
This can be useful when you have a logo or bug and you want to bring it on and off again
regularly. For example you could have a “live” logo that you want to fade on from time to time.
You can set up the logo in the downstream key 1 and then use the DSK 1 MIX button to bring it
on and off air. The duration of the transition when pressing the button will be set in the
downstream key LCD menu, or on a control panel.
You feed a keyer with an input or a media player and this can also be set up in the LCD menus
or on one of the control panels. If your switcher is new, then you can use the software control
panel to load the media pool with some graphic or logos so you have sources to use.
Press the DSK 1 MIX button to fade the downstream key 1 on and off air
86Using the ATEM Television Studio HD Front Panel