User's Manual

Please remember to set all devices to the correct IP address so they can all communicate.
You will need to set the IP address of the switcher via the LCD menu settings.
NOTE If setting up an additional ATEM hardware panel, you will need to set the DHCP
or fixed IP mode. If using a fixed IP address on the panel, set the IP address on the
panel. You will also need to set the switcher address on the panel itself so the panel
can identify your switcher on the network.
Lastly, you need to ensure your computer is connected and working on your network. Then
when you launch the ATEM Software Control application, you will be prompted automatically to
enter in an IP address for the switcher if ATEM Software Control cannot communicate with the
ATEM switcher. Use the IP address you just entered for the switcher. Then the ATEM Software
Control can find the switcher and communicate.
Changing the Switcher Network Settings
The switcher network settings are changed using the LCD menu settings, or you can use
Blackmagic ATEM Setup via USB.
Please follow the steps below:
To change the network settings using the LCD menu:
1 Press the 'menu' button to open the LCD menu.
2 Rotate the settings knob and press 'set' to select the 'settings' menu.
3 Scroll through the menu items until you see the 'network' settings and press 'set' to
select them.
4 Using the settings knob and 'set' button, select and adjust the number fields to change
the network settings.
5 Select 'save' and press 'set' to confirm the changes.
Your switcher will now ask to be power cycled. Press 'set' to confirm the change and then
power cycle your switcher.
Network settings can be changed using the LCD menu
26Connecting to a Network