User's Manual

Style Sets the bevel style for the DVE border.
Outer Width Adjusts the outside width of the border.
Inner Width Adjusts the inside width of the border.
Outer Soften Outside softness adjusts the outside edge of the border, the edge that
touches the background video.
Inner Soften Adjusts inside softness. This softness parameter adjusts the inside edge of
the border, the edge that touches the video.
Border/Shadow
Opacity
Opacity adjusts the transparency of the border and shadow, use this
setting to create interesting colored glass borders.
Bevel Position Adjusts the position of the 3D bevel on the border.
Bevel Soften Bevel softness adjusts the overall softness of the 3D border. A high value
for this parameter will result in a rounded or beveled border.
DVE shadow light source parameters
Enable Shadow Enables or disables the drop shadow.
Angle Adjusts the direction of the light source on the DVE or picture in picture.
Both the border and drop shadow, if available, are affected by changes to
this setting.
Altitude Adjusts the distance of the light source from the DVE or picture in picture.
Both the border and drop shadow, if available, are affected by changes to
this setting.
Setting up a DVE Key on Upstream Keyer 1
using ATEM Advanced Panels
1 Press the KEY 1 next transition button to enable the keyer on the preview output.
2 In the keyers LCD menu, select the DVE key type using the corresponding soft
control knob.
3 Select the fill source using the corresponding control knob or via the a source
button on the source select bus.
4 Press the system control left and right arrow buttons to navigate through the DVE
parameters, and use the soft control knobs to adjust settings, such as rotation,
position, size, mask settings, light source, border, and key frames for movement.
TIP When using the number pad to enter numeric values for settings, hold the 'reset'
button down for several seconds to enable negative values. Hold down again to return
to standard values.
139Keying using ATEM Switchers