User Manual
Table Of Contents
- Getting Started
- Using HyperDeck
- About SSDs
- HyperDeck Utility
- About Ultra HD 4K
- Accessing Your Clips
- Status Indicators
- Using the Display Menu on HyperDeck Studio Models
- Selecting Timecode Source
- SDI Start/Stop Recording
- Timecode Run Recording
- Shuttling with HyperDeck Shuttle
- Jog and Shuttle with HyperDeck Studio Models
- Ref Input
- RS-422 Control
- Installing the HyperDeck Shuttle Mounting Plate
- Using Your Favorite Editing Software
- Using Blackmagic Media Express
- Using Blackmagic UltraScope
- Using Blackmagic Disk Speed Test
- Developer Information
- Help
- Warnings
- Warranty

Warnings
73
Caution: Risk of Electric Shock
On HyperDeck Studio Pro's rear panel you will see a yellow warning label marked ‘Caution: Risk of Electric
Shock’. This is intended to warn users that there may be the presence of uninsulated “dangerous” voltage
within HyperDeck Studio Pro’s enclosure which may be of sufficient magnitude to constitute a risk of electric
shock to the user. Blackmagic Design advises you not to open the HyperDeck Studio Pro unit, but rather
contact your nearest Blackmagic Design service center should assistance be required.
Achtung: Stromschlaggefahr
Auf der HyperDeck Studio Pro-Rückseite befindet sich ein gelbes Warnetikett mit der Aufschrift 'Caution:
Risk of Electric Shock’. Dieses warnt den Benutzer vor einer möglichen, nicht isolierten, "gefährlichen"
Spannung innerhalb des HyperDeck Studio Pro-Gehäuses, die einen Elektroschock verursachen kann.
Blackmagic Design empfiehlt das Gehäuse des HyperDeck Studio Pro nicht selbst zu öffnen, sondern bei
Hilfebedarf das nächstgelegene Blackmagic Design Servicecenter zu kontaktieren.
Attention: Risque de choc électrique
Sur le panneau arrière du HyperDeck Studio Pro, vous verrai une étiquette d’avertissement de couleur jaune
sur laquelle est inscrit « Attention : Risque de choc électrique ». Cette mise en garde est destinée à avertir
les utilisateurs de la présence possible d’une tension « dangereuse » non isolée à l’intérieur du boîtier du
HyperDeck Studio Pro, laquelle tension pouvant avoir une magnitude suffisante pour constituer un risque
de choc électrique à l’utilisateur. Blackmagic Design vous déconseille donc d’ouvrir l’unité HyperDeck
Studio Pro, et vous recommande de contacter votre centre de service Blackmagic Design le plus proche en
cas de nécessité.
Caution label on rear panel
Warnetikett auf der Rückseite
Avertissement sur le panneau arrière
Warnings