User's Manual
If you have previously used broadcast decks with a search dial and edit controls, then
HyperDeck Extreme Control will feel very familiar to you. The controls follow a similar layout, so
you can operate the unit comfortably with confidence. The search dial even has a mechanical
clutch built in giving you a tactile response when using the shuttle or position modes.
This section of the manual will show you how to get started with your HyperDeck Extreme
Control, including plugging in power, connecting a HyperDeck Extreme 8K HDR, and making
sure the ‘remote’ button is enabled so you can control the unit remotely.
Plugging in Power
To power your HyperDeck Extreme Control, connect an IEC cable to the AC power input on the
rear of the unit. Youcan also use the 12V DC input if you want to connect external power or
redundancy via an external power supply, for example an uninterruptible power supply or
external 12V battery.
Connecting HyperDeck Extreme 8K HDR
HyperDeck Extreme Control features eight RS-422 connectors on the rear panel to allow
remote control of up to 8 HyperDeck units, or broadcast decks.
Connect the HyperDeck Extreme 8K HDR’s ‘remote in’ connector to your HyperDeck
controller’s RS-422 port labelled ‘1’ using an RS-422 serial cable.
54Getting Started with HyperDeck Extreme Control