User's Manual

4 Peel back the protective blue film on the motherboard heat pad.
5 Remove your NVMe SSD from the packaging and slide the card into place in the
PCIe slot. The slot will pivot up to 30 degrees to help installation.
6 Push the card down lightly onto the standoff mount and fasten the standoff screw.
You only need to tighten enough to keep the NVMe SSD snug.
7 Remove the protective blue film from the heat pad on the inside of the cover plate.
8 Replace the cover plate, the screws will only line up when installed correctly. You will
feel a little pressure on the cover plate from the density of the NVMe SSD combined
with the heat pads. This is normal as it is how they will conduct heat away from
the board.
9 Turn the unit right side up and reconnect your power and other cables.
52Using the Optional Internal Cache