User Manual

Getting Started

Plugging in Power

Getting started with your Blackmagic Video Assist is as simple as plugging in power,

connecting your video source, plugging in your audio and inserting an SD card.

To supply power, plug in the supplied power

adapter to your Blackmagic Video Assist’s

power input on the right side panel.

With external power connected, you can also

charge two LP-E6 type Lithium-Ion batteries,

which can be mounted to battery slots 1 and

2onthe back panel. To plug an LP-E6 type

battery into your Blackmagic Video Assist,

gently press the battery against the inside top

edge of the battery slot, then slide the battery

down against the back panel until you feel it

click and lock into place. Press the battery release button on the top panel to remove a battery.

For more information on battery use andhow to monitor the battery power remaining, refer to

the ‘settings’ section in this manual.

To turn on your Blackmagic Video Assist, press the power button on the right side panel.

Pressand hold to power off.

This section shows you how to

get started including:

■

Plugging in Power

■

Plugging in Video

■

Plugging in Audio

■

Inserting SD cards

Blackmagic Video Assist 4K

HDMI IN HDMI OUT SDI IN SDI OUT

ANALOG AUDIO IN

SD CARD SD CARD +12V POWER

PUSHPUSH

Connect external power to the

+12V power input. Press the

power button to turn the unit on.

A kickstand is provided so you

can mount the unit on your desk.

Simply lift the edge of the stand and

gently swing it into the open position.

The illustrations on this page show

the Blackmagic Video Assist 4K.

Blackmagic Video Assist 4K