User Manual

Settings
Looping playback
Tap the loop icon once to set your Blackmagic Video Assist to play back the current clip
on a continuous loop.
Tap again to play all your recorded clips on a continuous loop.
Tap a third time to turn loop off.
Shuttle through your clip by dragging the scrubbing slider forwards or
backwards. During playback mode, a panel will appear near the top left
corner of the screen. This panel displays the number of clips recorded on
your SD card, the current clip being played and the duration of the clip.
Settings
Changing Settings using the Touchscreen
Your Blackmagic Video Assist features a built in touchscreen. The touchscreen is used to
monitor your video and audio, plus change settings.
You can change most settings by tapping on the icons in the status strip at the top of the LCD.
Audio settings, such as levels adjustment or headphone volume, can be adjusted by swiping
the touchscreen up or down to reveal the on screen meters at the bottom of the LCD, then
tapping the audio meters.
Tap outside of the settings to hide a settings window. Swipe left or right to hide the
storage settings.
To change settings:
1 Tap the setting you wish to change in the status strip or on screen meters.
For example, if you want to set the recording codec, tap the codec indicator in the
status strip to open the codec settings. If you want to adjust audio levels, simply tap on
the audio meters.
2 In your chosen settings window, tap the menu buttons, arrows or slider icons to choose
from the available settings. Tap outside the window to close the settings.
10