User's Manual

To clean the particle transfer rollers, simply remove the O-ring
atthe end of each PTR spindle and slide off the roller.
NOTE If you find your particle transfer rollers losing stickiness even after washing,
orhave become difficult to mount and remove through age, wear and tear, you can
purchase new rollers from the Blackmagic Design website at
www.blackmagicdesign.com
Cleaning the Capstans
Clean the capstans as needed with a small amount of water and a lint free cloth.
Allow themtoair-dry. It is important to note that you should not use any solvents
whencleaningthe capstans.
Dusting
Dusting your scanner should be performed daily. This is as easy as using an air duster to
remove any particles from your scanner’s skid plate, drive wheels and any other film
contactsurface. This is best performed with the skid plate removed.
When dusting, it’s worth paying special attention to the small plastic infill on your scanner’s skid
plate. Dust buildup in this area can effect stabilization performance, so from time to time it’s
worth wiping this down with a damp cloth.
Pay special attention to the skid plate infill when dusting
56Servicing