User Manual

DSK parameters
Tie Switches the DSK TIE button for the respective keyer on or off.
Rate The mix rate at which the downstream keyer transitions on or off.
Key Switches the respective DSK CUT button on or off.
Auto Enables the respective DSK AUTO button to transition the keyer on air.
Fill Source Selects the source to be keyed.
Key Source Selects the cut source which masks the fill source.
Pre Multiplied Key Identifies the key signal as a pre-multiplied key.
Clip The clip level adjusts the threshold at which the key cuts its hole.
Decreasing the clip level reveals more of the background. If the
background video is completely black then the clip value is too high.
Gain The gain adjustment electronically modifies the angle between on and
off thereby softening the edges of the key. Adjust the gain value until
the edge softness is desirable but the background video luminance, or
brightness, is not affected.
Invert Key Inverts the key signal.
Mask Allows you to mask out sections of the key. For example, if you need to
select only a specific section of a graphic, you can use the mask setting to
select only the area of the graphic you want to use. To return the mask to
the default settings, select ‘reset mask’ and press the set button.
112Keying using ATEM Mini