User Manual

Clip EQ
Each audio clip in the Timeline has a four-band equalizer that has both graphical and numeric
controls for boosting or attenuating different ranges of frequencies within that clip, before it
even gets to the EQ built into the mixer. Each band has controls for the filter type (Bell,
Lo-Shelf, Hi-Shelf, Notch), Frequency, Gain, and Q-factor (sharpness of the band), with the
available controls for each band of EQ changing depending on the filter type.
When a channel strip’s EQ is enabled, the EQ button displays the equalization curve that’s
being applied. This indicator cannot be adjusted; you must open the EQ window to
make modifications.
The channel strip’s EQ indicator, (Left) EQ is at detent, (Right) EQ is adjusted
Master EQ Controls
The Equalizer window has the following overall controls:
 Enable button: Turns the overall EQ effect off and on, without resetting the controls.
 Reset button: Resets all controls of the EQ window to their defaults.
Graphical EQ controls
A graph at the top shows a curve with handles that correspond to each of the enabled EQ
bands listed below. You can drag any numbered handle to boost or attenuate the range of
frequencies governed by that band, using whatever type of equalization that band has
been set to.
Chapter – 36 Working with Audio in the Edit Page 758