User Manual

Table Of Contents
Trimming only the clip in V3 by soloing the V3 Auto Select controls
Using Manual Selections to Control Which Clips Are Trimmed
It’s important to know that manual selections you make in the Timeline that highlight specific
clips always take precedence over whatever the Auto Select controls are set to. For example,
ifAuto Select is turned on for tracks V1, V2, and V3, but you’ve selected a clip on track V1, only
the selected clip will be still be affected by whatever operation you decide to perform. For
example, if you use Trim End, the clip on track V1 will be affected.
Manual selection of a clip on track V1 overrides the Auto Select controls on all tracks
Using Auto Select to Control Which Tracks Are Rippled
Each track’s Auto Select control is also used to control how trimming and editing operations
that ripple the Timeline affect timelines with multiple tracks and superimposed clips. Using Auto
Select controls, you can turn off rippling on specific tracks, while leaving it on for others.
Chapter – 34 Trimming 706