User Manual

Table Of Contents
Two-up display when rolling an edit
Ripple edit: To ripple the outgoing or incoming part of an edit to add or remove media
to a clip while simultaneously moving all other clips at the left in the Timeline to make
room, click the Trim tool, and drag an edit point to a new position in the Timeline.
Selected outgoing half of an edit point before ripple
Rippled clip is shorter, the rest of the Timeline has moved left to fill the gap
When rippling an edit, a 2-up display shows the continuity of action from the outgoing
frame of the clip to the left to the incoming frame of the clip to the right. Which frame
updates depends on which side of the edit you’re rippling.
TIP: You can temporarily disable this two-up display by pressing the Shift key
while you ripple so that you only see the frame at the position of the playhead.
This makes it possible for you to see which frame passes the playhead by as
you ripple the Timeline. You can toggle this two-up display off completely by
selecting View > Enable Preview During Editing.
Chapter – 34 Trimming 696