User Manual

Table Of Contents
4 Choose whether you want to switch both the audio and video, just the video, or just the
audio using the Audio/Video selection buttons at the bottom center of the Multicam
Viewer. You can also choose Edit > Multicam > Video and Audio (Option-Shift-[ ), Video
Only (Option-Shift-] ), Audio Only (Option-Shift-\).
Buttons for choosing whether to switch the video, the audio, or both
5 Start playback, and while watching the program play, do one of the following:
Click any angle in the Multicam Viewer to insert a cut in the Timeline and switch to that
angle. As you cut-and-switch, the cuts immediately appear in the Timeline while you
play onward.
Option-click any angle to switch the angle used by the current clip without adding a cut.
This is useful if you later regret the angle you cut to and just want to switch the entire
segment since the last cut you made. This can also be accomplished by choosing Edit >
Multicam > Previous Angle (Command-Shift-Left Arrow) or Next Angle (Command-Shift-
Right Arrow).
As you play, the entire mix in the Timeline will play along with what you’re switching, so
you can work in context.
A timeline while it’s being edited using cut and switch
6 When you’re ready to stop multicam editing, simply stop playback. If you want to start
trimming the Timeline to fine-tune what you’ve done, choose Source from the Source
Viewer mode drop-down, and you can re-edit and trim the multicam clips in the
Timeline just like any others.
Chapter – 32 Multicam Editing 673