User Manual

Table Of Contents
1 Set In and Out points in a source clip, either in the Media Pool or in the Source Viewer.
Setting source clip In and Out points
2 To set where you want the incoming clip to go, set the destination control to the tracks
you want to edit onto, and then do one of the following:
Move the Timeline playhead to the frame you want to use as the Timeline In point for
the edit.
Set a Timeline In point for the edit.
Using the playhead to act as a Timeline In point
3 To make the edit, click the Overwrite Clip button in the toolbar, press the F10 key, or
drag a clip onto the appropriate overlay in the Timeline Viewer.
The resulting edit; the duration of the source clip defines the duration of the edit
Chapter – 30 Three- and Four-Point Editing 627