User Manual

Table Of Contents
Press Option-1 through 8 to set a video destination, or press Option-Command-1
through 8 to set an audio destination on tracks 1 through 8.
Moving the destination control to track V2, labeled “Titles”
You can also disable the Video or Audio destination controls in situations where you want to
edit a source video clip into the Timeline without its audio, or vice versa.
To disable or reenable a destination control, do one of the following:
Click an already assigned destination control to toggle it off and then on again.
Pressing the “assign destination control” repeatedly for a given track (Option 1-8 for
video, Option-Command-1-8 for audio) toggles the destination track on and off.
Disabled destination controls are highlighted gray.
A disabled destination control
Setting In and Out Points in the Timeline
When you’re setting up an edit to the Timeline, you can oftentimes get away with simply putting
the Timeline playhead at the frame where you want to edit the incoming source clip. In the
absence of In or Out points, the playhead is used as the In point. However, you can set up
different kinds of edits by setting specific In and Out points to define different ranges of
the Timeline.
Methods of setting and clearing In and Out points in the Timeline:
To set an In or Out point: Select the Timeline or Timeline Viewer by clicking or pressing
the Q key, then use the transport controls, jog bar, or control panel buttons to move the
playhead, and press the I key to set an In point, or the O key to set an Outpoint.
To clear In or Out points: With the Timeline Viewer selected, press Option-I to clear the
current In point, or Option-O to clear the current Out point.
To clear both the In and Out points at once: Press Option-X.
Chapter – 30 Three- and Four-Point Editing 619