User Manual

Table Of Contents
b To cut or copy segment of a clip, move the playhead so that it intersects the clip you
want to cut or copy. If the playhead intersects a clip on a selected track, that clip
should become selected. Then, using JKL and the I (In) and O (Out) keys, mark a
range in the Timeline that includes the segment of the clip you want. That segment
should appear highlighted as a result.
Cutting or copying a segment of a clip using In and Out points
4 Making sure the playhead is over the section of the waveform that you want to use as
the frame to move the clip by, press Command-X to cut or Command-C to copy that
clip (you can also right-click a clip and choose Copy or Cut). That clip will immediately
become highlighted.
Cutting or copying a clip at the position of the playhead
5 At this point, there are two things you can do to position the cut or copied clip to the
position in the Timeline at which you want to paste it:
a Moving the playhead will now also move the clip you cut or copied, shown as a
ghost clip with waveform that’s “attached” to the playhead at the frame you chose.
Whether you drag the playhead with your mouse or use JKL to move the playhead
through the Timeline, the cut or copied clip will move along with it, so that moving
the playhead repositions the cut or copied clip on that track.
Chapter – 154 Editing Basics in the Fairlight Page 3221