User Manual

Table Of Contents
4 Click the button or list item of the destination you want to patch on the right side.
A selected audio source and audio destination pair
5 Click the Patch button at the bottom right of the window. The source and destination
will both display the connection they’re patched to.
To unpatch a source and destination pair:
1 Click a button or list item corresponding to a source or destination you want to unpatch.
2 Click Unpatch.
Choosing Audio Source and Destination Controls
The Audio Source and Destination drop-down menus let you choose different categories of
source and destination controls to patch together.
The following Audio Source options are available:
Audio Inputs: The available physical audio inputs on your workstation, for example
SX-36, MADI, or system audio. Useful when patching to record audio.
Track Repro: Short for Reproduction, this is the signal from the track playback,
before any processing
Track Send: Track Insert send
Track Direct: Track Direct Out, can be pre or post the track fader, with an offset
MT-Bus Dir: Multitrack Bus Direct Out, can be pre or post the multitrack bus
master fader, with an offset
MT-Bus Out: Multitrack Bus Out, always post the Multitrack bus master fader
Aux-Bus Send: Aux bus master insert send
Aux-Bus Dir: Aux Bus Direct Out, can be pre or post the Aux bus master fader,
with an offset
Aux-Bus Out: Aux Bus Out, always post the Aux bus master fader
Sub-Bus Send: Sub bus master insert send
Sub-Bus Dir: Sub Bus Direct Out, can be pre or post the Sub bus master fader,
with an offset
Sub-Bus Out: Sub Bus Out, always post the Sub bus master fader.
CR-Mon Dir: Monitor system Direct out. Post fold up/down matrix, pre the
Monitor VolumeLevel/Dim/Mute
CR-Mon Out: Monitor system output. Post fold up/down matrix and
Monitor VolumeLevel/Dim/Mute
Main Send: Main bus master insert send
Chapter – 150 Setting Up Tracks, Buses, and Patching 3167