User Manual

Table Of Contents
The Display Options group
This group lets you turn the visibility of different onscreen controls off and on.
Checkboxes let you Show Trackers, Show Center (the red tracking center point), Show
Paths (the tracked motion paths), and Show Active Patches. A slider lets you adjust the
size of each patch window.
Show Comp Result lets you see the composited foreground layer against the
background layer.
Positioning
The Positioning controls govern the second stage of the match moving process. They provide
everything you need to transform the foreground image to fit against the background by
moving, corner-pinning, and resizing.
The controls that are exposed when
Main Controls is set to Positioning
Canvas Options
The Canvas Controls pop-up menu lets you switch between corner-pin controls, where
dragging the four corners lets you corner-pin, dragging the center lets you reposition,
and dragging the top, bottom, and sides lets you resize vertically or horizontally.
A Reset Corners button lets you reset the grid to full screen, if you need to scrap what
you’re doing and try again.
The Display Options group
This group lets you turn the visibility of different onscreen controls off and on.
Checkboxes let you Show Trackers, Show Center (the red tracking center point), and
Show Paths (the tracked motion paths).
Show Comp Result lets you see the composited foreground layer against the
background layer.
Compositing
The Compositing controls govern the third stage of the match moving process, to use when
fitting the foreground image against the background image to make a seamless composite.
Note, if you need to color correct the foreground image to match the background, you’ll need to
add a corrector node between the Ext. Matte that’s routing in the foreground image into the
Color page and the FX node that’s doing the compositing.
Chapter – 147 ResolveFX Transform 3105