User Manual

Table Of Contents
If you marked the first tracked frame in the second half of the clip, then use the
transport controls to move the playhead to the last tracked frame of the first half of
the clip and press the INTRPLT FWD soft key.
To move the playhead to different “cue” frames:
Press the CUE START, CUE LOWER, CUE UPPER, or CUE END soft keys on the
T-bar panel.
To use Interactive mode:
1 Press the INTERACTIVE soft key at the left of the Center panel.
Additional button controls appear on the soft keys of the Transport panel, including
INSERT (POINTS), DELETE (POINTS), CLEAR (POINTS), and SET POINT.
2 Do one of the following:
To eliminate all tracking points, press the CLEAR soft key.
To add a single tracking point, press CURSOR (above the fourth trackball), use the
fourth trackball to position the onscreen cursor over the feature you’d like to add a
tracking point to, and then press the SET POINT soft key.
To eliminate a range of tracking points in order to prevent the tracking of an
undesirable feature, use the mouse to draw a bounding box around the tracking
points you want to remove, and press the DELETE soft key.
To add a range of tracking points to a specific feature, use the mouse to draw a
bounding box around the feature you want to track, and press the INSERT soft key.
3 Use the TRACK FWD, TRACK REV, and STOP TRACK soft buttons on the left side of the
Center panel to perform the necessary tracking.
4 Press the INTERACTIVE soft key again to leave Interactive mode.
Chapter – 133 Sizing and Image Stabilization 2989