Manualshelf

User Manual

ManualsBrandsBlackmagic Design ManualsMixer and Video ControllerDaVinci Resolve Mini Panel + DaVinci Resolve Studio Tribute - CONTROLLER FOR RESOLVE DAVINCI
2981298229832984298529862987298829892990
Table Of Contents
The background sky layer after it’s been matched to the motion of the foreground layer, the sky now
follows along with the motion of the camera in the superimposed clip
Tracking and Stabilizing with
the DaVinci Control Panel
All of the tracking commands are available via the DaVinci Resolve control panel.
To open and close tracking controls:
Press OBJECT TRACK MODE at the top of the T-bar panel.
All of the tracking controls appear on the soft keys of the Center and T-bar panels.
To do simple tracking:
Use the TRACK FWD, TRACK REV, and STOP TRACK soft buttons on the left side of the
Center panel.
Press SHOW TRACK if you want to see the resulting motion path.
To turn tracking on and off for Pan, Tilt, Zoom, and Rotate:
1 Press the P/T/Z/R ENABLE soft key. The middle four soft keys of the Center panel
change to display PAN ON/OFF, TILT ON/OFF, ZOOM ON/OFF, and ROTATE ON/OFF.
2 Use these buttons to toggle any of these checkboxes on or off, then press BACK to go
back to the other tracking controls.
To interpolate between two separately tracked ranges of frames:
1 Use the transport controls to move the playhead to the first frame you want to place a
mark, and press MARK. A Viewer Mark appears on the tracking bar, identifying either
the beginning or the end of the gap in that clip’s motion tracking data.
2 If necessary, use the transport controls to move the playhead to the second frame
where you want to place a mark, and press MARK. A second Viewer Mark appears in
the tracking bar, identifying both the beginning and end of the gap in that clip’s motion
tracking data.
3 To perform the interpolation, do one of the following:
–
If you marked both the first and last tracked frames that surround a gap in tracking
data, press the INTRPLT BETWEEN soft key.
–
If you marked the last tracked frame in the first half of the clip, then use the transport
controls to move the playhead to the first tracked frame of the second half of the clip
and press the INTRPLT REV soft key.
Chapter – 133 Sizing and Image Stabilization 2988