User Manual

To make curve adjustments:
Adjust the 0% LUM, 20% LUM, 40% LUM, 60% LUM, 80% LUM, or 100% LUM
rotary knobs.
By default, all adjustments you make using these controls are ganged across all four YRGB
curve controls. However, if you turn Custom curve ganging off, then these controls only affect
the Luminance curve.
These controls correspond to the following default control point positions on the
Curve controls.
Each rotary curve control on the DaVinci control
surface corresponds to one of these six default
control point positions
You also have the option of using the fourth trackball from the left to adjust individual control
points on curves to any position you like. This works for all curves in DaVinci Resolve that have
control surface mappings.
Methods of selecting and adjusting individual control points
using the master trackball of the Center panel:
 To select a control point to adjust: Spin the fourth ring control to the left or right to
select the next control point in that direction (it takes about half of a turn to select
another control point).
Selected control points are highlighted in cyan.
 To move a selected control point: Adjust the fourth trackball to move the control point
up, down, left, or right. Selected control points are constrained between whichever
control points are to the left and right.
Another set of rotary knobs let you adjust Curve Mix and YSFX parameters.
To adjust the Curve Intensity sliders:
Adjust the LUM CURVE, RED CURVE, GREEN CURVE, or BLUE CURVE rotary knobs.
To make YSFX adjustments:
Adjust the LUM YSFX, RED YSFX, GREEN YSFX, or BLUE YSFX rotary knobs.
Chapter – 118 Curves 2682