User Manual

Table Of Contents
Adding Default Anchors to the Custom Curves
You can also choose Default Anchors from the option menu of the Curve palette in Custom
mode to place three additional control points on the curve, dividing the curve into five
segments that affect the shadows, low midtones, medium midtones, high midtones, and
highlights of the image.
Custom curve with Default Anchors exposed
Ganging and Unganging Custom Curves
By default, the Custom curves are ganged, so that curve adjustments affect a clip’s YRGB
channels all together, resulting in an adjustment to image contrast that’s similar to using the
Master Wheels in the Color Wheels palette, or the ring controls of the DaVinci control panel.
When making this type of adjustment, increasing contrast also increases image saturation, while
reducing contrast also reduces image saturation. Since curves can be manipulated with greater
specificity than the three Master Wheels, you can make much finer contrast adjustments using
the YRGB curves than when using the Master Wheels only.
Turning ganging off lets you use the full power of Custom curves to alter the image. Unlike the
Color Balance controls, each of which adjust all three color channels simultaneously, the Curve
controls let you adjust each channel individually when Gang Custom Curves is turned off.
To disable Custom curve ganging:
Click the Curve Edit button that corresponds to the curve channel you want to edit.
Clicking any Curve Edit button highlights that curve to make it easy for editing when
curves overlap one another. Once one or more curves is offset from the others, you
can freely edit any curve by dragging its control points.
Custom Curve Edit
buttons are to the left, the
Gang button is to the right
To re-enable Custom curve ganging:
Click the Gang button to the left of the Curve Edit buttons.
Chapter – 118 Curves 2679