User Manual

Scale Input
By default, the Probe generates the Black Value when the probed area results in a value of 0
(i.e., black), and it generates its White Value when the probed area results in a value of 1 (i.e.,
white). By using this range control, you can modify the sensitivity of the Probe.
Black Value
The value that is generated by the Probe if the probed area delivers the result set in Scale
Input Black.
White Value
The value that is generated by the Probe if the probed area delivers the result set in Scale
Input White.
Out of Image Value
The value that is generated by the Probe if the probed area is outside the frame boundaries of
the probed image. If probing a rectangle, this value does not generate before the entire
rectangle is outside the frame boundaries of the image to be probed.
Publish
Only parameters that are animated will be available from the Connect To menu. To connect to
non-animated parameters, you must Publish them first. Animated controls are automatically
published, whereas static controls must be published manually.
To publish a static control, right-click the control and select Publish from the contextual menu.
Controls Tab
The Controls tab shows the published control available for linking to other controls.
Published Value
The display of the published control is obviously dependent on which control is published from
which node.
Resolve Parameter
The Resolve Parameter Modifier is used when creating a transition template in Fusion for use in
DaVinci Resolve’s Edit page or Cut page. When building a transition in Fusion, the Resolve
Parameter modifier is added to any control you want to animate. The Resolve Parameter
modifier automatically animates the parameter for the duration of the transition, allowing you to
trim the transition in the Edit page or Cut page.
Chapter – 111 Modifiers 2535