User Manual

Inspector
Controls Tab
The Controls tab for Perturb is mainly used for controlling the Strength, Wobble, and Speed
parameters of the random jitter.
Value
The content of this control depends on what type of control the modifier was applied to. If the
Perturb modifier was added to a basic Slider control, the Value is a slider. If it was added to a
Gradient control, then a Gradient control is displayed here. Use the control to set the default, or
center value, for the Perturb modifier to work on.
Jaggedness
(Polylines and meshes only) This allows you to increase the amount of variation along the length
of the polyline or mesh, rather than over time. Increasing Jaggedness gives a squigglier
polyline or more tangled mesh, independent of its movement.
Chapter – 111 Modifiers 2532