User Manual

Inspector
Controls Tab
This tab provides nine number controls and nine point controls. The values of the number
controls can be referred to in an expression as n1 through n9. The X-coordinate of each point
control can be referred to as p1x through p9x, while the Y-coordinate is p1y through p9y.
These values can be set manually, connected to other parameters, animated, and even
connected to other Expressions or Calculations.
Number Out Tab
Mathematical formulas are entered using the Number In and Point In values from the Controls
tab. The output modifies the control in which the Expression was applied. See below for the
syntax to use in this field.
Chapter – 111 Modifiers 2515