User Manual

Set Image Coordinates at Subdivision Level
This checkbox defaults to enabled and sets the image coordinates at the subdivision level.
Force Destination Render
This checkbox defaults to enabled and forces a destination render.
Contextual Menu Options
The Grid Warp node places a submenu for both source and destination grids in the viewer’s
contextual menu. Both menus have the exact same name, where only the menu for the active
grid is populated with options. The other menu is empty. The contextual menu options are also
available from the toolbar that appears in the viewer.
Modify Only/Done
These two options set the mesh to Modify Only and Done modes, respectively. Select Modify
Only to edit the mesh or Modify Done to prevent any further changes to a mesh.
Smooth/Linear
Use Smooth and Linear options to apply or remove smoothing from selected vertices.
Auto Smooth Points
When Auto Smooth Points is enabled, the vertices in the grid are automatically smoothed
whenever they are moved. This is generally enabled by default.
Z Under/Z Same/Z Over
When two vertices in a grid overlap, one ends up getting clipped by the other. Z Under, Z Same,
and Z Over are used to select which vertices are rendered on top and which are
rendered behind.
Select All
This option selects all points in the mesh.
Chapter – 110 Warp Nodes 2493