User Manual

Inspector
Controls Tab
The Controls tab contains parameters that configure the onscreen grid as well the type of
distortion applied when a control point on the grid is moved.
Source and Destination
The Source and Destination buttons determine whether the source grid or destination grid is
currently active. Only one grid can be displayed or manipulated at a time. The selected button
is highlighted to indicate that it is the currently active grid.
All other controls in this tab affect the grid selected by this control.
Selection Type
These three buttons determine the selection types used for manipulating the points. There are
three options available.
Selected
When in Selected mode, adjustments to the grid are applied only to the currently selected
points. This mode is identical to normal polyline operation.
Region
In Region mode, all points within the area around the mouse pointer move when the mouse
button is clicked. New points that enter the region during the move are ignored. Choosing this
option exposes Magnet Distance and Magnet Strength controls to determine the size and falloff
of the area.
Magnetic
In Magnetic mode, all points within the area around the mouse pointer move when the mouse
button is clicked. New points that enter the region during the move are affected as well.
Choosing this option exposes Magnet Distance and Magnet Strength controls to determine the
size and fall off of the area.
Chapter – 110 Warp Nodes 2489