User Manual

Controls Tab
The adjustments in the Controls tab are used to change the Dent style, position, size,
and strength.
Type
Select the type of Dent filter to use from this menu. All parameters for the Dent can be
keyframed.
Dent 1
This creates a bulge dent.
Kaleidoscope
This creates a dent, mirrors it, and inverts it.
Dent 2
This creates a displacement dent.
Dent 3
This creates a deform dent.
Cosine Dent
This creates a fracture to a center point.
Sine Dent
This creates a smooth rounded dent.
Center X and Y
This positions the Center of the Dent effect on the image. The default values are 0.5, 0.5, which
center the effect in the image.
Size
This changes the size of the area affected by the dent. Animate this slider to make the
dent grow.
Strength
This changes the overall strength of the dent.
Common Controls
Settings Tab
The Settings tab in the Inspector is also duplicated in other Warp nodes. These common
controls are described in detail at the end of this chapter in “The Common Controls” section.
Chapter – 110 Warp Nodes 2482